4 Axis I.T.C.™ Tecnology
The I.T.C.™ System compensates for the natural taper that is produced by the water jet while cutting. The I.T.C.™ enables the operator to enhance the squareness of the cut material, top to bottom, while allowing highest possible cutting feed rates. The water jet position is compensated up to 2 degrees, via the NC control of the motion system. This ensure a high quality part at low cost.
During the I.T.C.™ compensation, the jet is also directed towards the piece in order to reduce the "Tail Delay" effect as well as the accelerarion-deceleration ramp times around the corners, for faster and more economical cutting cycles.