 MACHINES |
|
|
| Waterjet |
 |
 |
| |
The I.T.C (Intelligent Tapering Control™ ) cutting System is able to correct the tapering and achieve the perpendicular of the cut compensating by CNC the inclination of the high pressure waterjet +6° and increasing to the highest possible cutting speed for the lower cost per part. During this operation the Jet is direct also towards the piece in order to reduce the “Rc”(Tail Delay) effect and the acceleration-deceleration ramps time on the corner for the fastest and economical cutting cycle. The WaterCad-Cam™ generates the check program just by a Click |
| |
 |
| |
DX 3000 |
| |
X = 1.600 mm
Y = 3.000 mm
Z = 180 mm |
Net Cutting Area
(X, Y, Z) |
X = 5'1/2
Y = 10'
Z = 7"
d = infinite |
| 1.900 mm x 3.200 mm |
Inside Table Working Area |
6"1/2 x 10"1/2 |
2.300 mm x 4.300
x 1.900 mm H |
Overall Table Dimension |
8 x 14x 6'1/2H |
| 0 -:- 20 mt/min |
Rapid Speed |
0 -:- 67' / min |
| 3000 Kg. |
Table Weight |
7.000 lb |
| +/- 0,05 mm |
Accuracy and Repeatibility |
+/- 0,002'' |
|
| |
|
| |
THE SET |
| |
| Model |
Net Cutting Area |
SUPREMA
DX |
| 1200 |
1.200 mm x 1.200 mm
4' x 4' |
 |
| |
| 3000 |
3.000 mm x 1.600 mm
10' x 5'1/2 |
 |
| |
| 3200 |
3.200 mm x 2.000 mm
11' x 7' |
 |
| |
| 4000 |
4.000 mm x 2.000 mm
13' x 7' |
 |
| |
|
| |
| 6000 |
6.000 mm x 2.000 mm
20' x 7' |
 |
| 6250 |
6.000 mm x 2.500 mm
20' x 8' |
| 6300 |
6.000 mm x 3.000 mm
20' x 10' |
|
| |
|
| |
THE PUMP |
| |
High pressure Intensifier Pump |
| |
Model
|
|
Power
|
N. Cylinders
|
Max. Orifice Size
|
| XP-30 |
2,24 lt/min - 0,6 GPM |
21 kW - 30 Hp |
2 |
0,011" = 0,27 mm |
| XP-60 |
4,69 lt/min - 1,2 GPM |
45 kW - 60 Hp |
2 |
0,015" = 0,38 mm |
| XP-120 |
9,4 lt/min - 2,4 GPM |
94 kW - 120 Hp |
4 |
2 x 0,015" = 2 x 0,38 mm |
|
| |
|
| |
Design Pressure 4.130 Bar
Dual Pressure Control
PLC alarms controlStainless Steel Soundproofing cover |
| |
|
|
|
|
